Extreme Networks ExtremeWare 7.7, Справочник по командам

Страница: 2470 / 2620

2470 ExtremeWare 7.7 Command Reference Guide
H-VPLS Commands—BlackDiamond Switch Only
configure mpls rsvp-te profile
configure mpls rsvp-te profile <profile_name> {bandwidth <bps>}
{setup-priority <priority>} {hold-priority <priority>} {retry-timeout
<seconds>} {hop-count <number>} {ping-interval <seconds>} {metric [<metric>
| igp-tracking} {record [enabled | disabled]} {mtu <number>}
Description
None
Syntax Description
Default
N/A.
Usage Guidelines
The mtu keyword optionally specifies the MTU value transport payload packet (customer packet). The
mtu value is exchanged with vpls configured peer nodes. All VPLS peer nodes must be configured with
the same mtu value. If the mtu values do not match, VC-LSPs cannot be established between VPLS
peers. By default the VPLS mtu is set to 1500. The configurable mtu range is 1492 through 9216.
Changing the mtu setting will cause established VC-LSPs to terminate. VPLS payload packets may be
dropped if the VPLS MTU setting is greater than the MPLS MTU setting for the VC-LSP interface. The
vplsping command may be used to verify end-to-end path connectivity for specific payload packet
sizes.
Example
None
History
This command was first available in an ExtremeWare 7.3.0.
Platform Availability
This command is available on the BlackDiamond switch only.
profile_name Identifies the profile
bps bits per second
priority
seconds
number
seconds
metric
mtu Specifies the MTU value transport payload packet (customer packet).