Alcatel Omni Switch/Router, Руководство пользователя

Страница: 780 / 1100

NetBIOS Relays
Page 26-16
Configuring NBDD Relay
If you want to send
NetBIOS
datagrams across networks, you should enable the
NBDD
relay.
To enable the
NBDD
relay, enter
3=y
at the command prompt of the UDP Relay Configuration
screen. The screen redisplays similar to the following:
UDP Relay Configuration
1) BOOTP/DHCP Enabled : Yes
11) Server Address{list/add/delete} : UNSET
12) Forward Delay : 3
13) Maximum Hops : 4
2) NBNS Enabled : Yes
21) Next-hop Address {list/add/delete} : UNSET
22) Forward to VLANs {list/add/delete} : UNSET
3) NBDD Enabled : Yes
31) Next-hop Address {list/add/delete} : UNSET
32) Forward to VLANs {list/add/delete} : UNSET
4) +Generic Services Menu
Command {Item=Value/?/Help/Quit/Redraw/Save} (Redraw) :
Either a Next-hop Address or a Forward to VLANs value must be configured for the relay.
Next-hop Address
Use this parameter to list, add, or delete the server address(es) to which the
NBNS UDP
relay
will forward. The default is
UNSET.
This value redisplays as
SET
when at least one address is
configured. Up to 8 addresses may be configured. You can list, add, or delete addresses by
entering
31=l
,
31=a
, or
31=d
on the command line.
Forward to VLANs
Use this parameter to list, add, or delete
VLANs
to which the
NBNS UDP
relay will forward.
This default is
UNSET
. This value changes to
SET
when at least one
VLAN
is configured. Up to
32
VLANs
may be configured. You can list forwarding
VLANs
, or add or delete
VLANs
from the
forwarding list by entering
32=l
,
32=a
, or
32=d
on the command line. Entries marked with an
asterisk indicate the
VLANs
to which the relay will forward.