Alcatel Omni Switch/Router, Руководство пользователя

Страница: 620 / 1100

Defining and Configuring AutoTracker Policies
Page 20-4
Defining and Configuring AutoTracker Policies
You can define AutoTracker policies by port,
MAC
address, protocol, network address, user
definition, or port binding. You can define multiple policies for a mobile group or
AutoTracker
VLAN
if you wish. A port or device is included in a mobile group or AutoTracker
VLAN
if it matches any one rule. For example, you can define rules based on ports, rules
based on
MAC
address, and rules based on protocol in the same mobile group or AutoTracker
VLAN
. However, defining multiple rules is not trivial – exercise extreme care when you do so
and make sure that you understand the consequences of your definitions. In most situations,
it is advisable to use one of AutoTracker’s predefined rules.
The sections below provide directions for setting up each type of AutoTracker policy. Follow
the directions for the policy you wish to set up.
Port Policy See Defining a Port Policy on page 20-5.
MAC Address Policy See Defining a MAC Address Policy on page 20-6.
Protocol Policy See
Defining a Protocol Policy
on page 20-8.
Network Address Policy See Defining a Network Address Policy on page 20-11.
User-defined Policy See
Defining Your Own Rules
on page 20-13.
Binding Policy See Defining a Port Binding Policy on page 20-15.
DHCP Port Policy See
Defining a DHCP Port Policy
on page 20-20.
DHCP MAC Address Policy See Defining a DHCP MAC Address Policy on page 20-21.
Where These Procedures Start
These policy configuration sections start in the middle of a sequence of steps with the
crgp
or
modatvl
commands. During the
crgp
command prompt sequence you can configure polices
for mobile groups or for VLANs within non-mobile groups. The
modatvl
command contains an
option for adding policies (option #3). The procedures in these sections pick up at the point
after you choose to either to configure AutoTracker rules (
crgp
) or add more rules (
modatvl
).