8A
la
rm
DX100
8.3
A
la
rm Me
ssa
ge List
8-335
13
A job specified at job search did
not exist in the memory.
Software operation
error occurred
(1)Reset the alarm.
(2)If the error occurs again, delete the job where the alarm occurred.
(3)If the error occurs again after the previous measures were executed,
initialize the job file in the maintenance mode, and then load the saved job
file.
(4)If the error occurs again though the previous measures were executed,
save the CMOS.BIN in maintenance mode, and then contact your Yaskawa
representative about occurrence status (operating procedure).
14
There was an instruction that did
not exist in a job because of
inconsistency of the system
software.
Software operation
error occurred
(1)Reset the alarm.
(2)If the error occurs again, delete the job where the alarm occurred.
(3)If the error occurs again after the previous measures were executed,
initialize the job file in the maintenance mode, and then load the saved job
file.
(4)If the error occurs again though the previous measures were executed,
save the CMOS.BIN in maintenance mode, and then contact your Yaskawa
representative about occurrence status (operating procedure).
16
Unused handles were lacking
when an attempt was made to
open a job.
Setting error
(1)Check the following settings.
·The number of call job stacks
Set the job configuration that decreases the number of call job stacks.
Alarm
Number
Alarm Name
Sub
Code
Meaning
Cause
Remedy