10.5 Metasys N2 Communications
730
YASKAWA
SIEPYAIH6B01A HV600 AC Drive Bypass Technical Reference
Figure 10.12 Termination Resistor DIP Switch S1
■
Wiring Diagram for More than One Bypass
shows how to wire more than one connected bypass using serial communications.
Figure 10.13 Wiring Diagram for More than One Bypass
Note:
When you install the bypass at the end of the network line, set DIP switch S1 to
“
ON
”
to enable the termination resistor. Set DIP switch S1 to
“
OFF
”
on all other bypasses.
◆
Bypass Operations by Serial Communications
Parameters will apply to the settings when the bypass is running during serial communications. This section gives
information about the available functions and their related parameters.
■
Executable Functions
A controller can do these operations with serial communications. Parameter settings (except
H5-xx
) do not have an
effect on the availability of these operations.
•
Monitor the bypass status and operate the bypass
•
Set and view parameters
•
Fault Reset Procedure
PLC
R+
Bypass
OFF
R-
S+
S-
IG
2
3
1
TXRX+
TXRX-
IG5
S1
Bypass
OFF
2
3
1
TXRX+
TXRX-
IG5
S1
Bypass
ON
2
3
1
TXRX+
TXRX-
IG5
S1
Summary of Contents for H6B1A002
