TEXIO LSG-1050H, Instruction Manual

Page: 135 / 205

125
3-6-1. BATT Test function setting parameters
Parameters BATT No. Selects one of 12 BATT test setup
memories.
Memo A user-created note for the currently
selected BATT Test function.
Mode Select a discharge operation mode. (CC,
CR, CP)
Range Select I Range (High, Middle, Low)
and V Range (High, Low).
Example:
ILVL(I range Low, V range Low)
Setting Sets the values corresponding to the
defined discharging mode (CC mode in A,
CR mode in mS and CP mode in W).
Slew Rate
=
Sets the test rising slew rate in mA/us (not
adjustable for CP mode).
Slew Rate
?
Sets the test falling slew rate in mA/us (not
adjustable for CP mode).
Stop Volt Sets the voltage at which the test should
be interrupted. The value must be lower
than the battery start voltage.
Stop Time Sets the time after which the test should be
interrupted (max value is 999h: 59m: 59s).
Stop AH Sets the discharged energy rate at which
the test should be interrupted (Max value is
9999.99Ah).
Datalog timer Sets the time interval for data capture (1
～
120 seconds). Up to 65,535 data can be
saved when running data logging function.
When logging data reaches to the
maximum amount, it won’t be saved and
be ignored.