TEXIO LSG-1050H, Instruction Manual

Page: 107 / 205

97
Edit
Description Normal Sequence configuration is split into Timing Edit
configuration and Data Edit configuration.
Timing Edit configuration is used to configure the actual
sequences, such as mode, range, loops and chains.
Data Edit configuration is used to create the actual steps
used in each sequence.
See below for a description of each.
Timing Edit
Overview A Normal Sequence contains the following timing settings
for each sequence:
Setting Setting Range Description
Start S01 ~ S10 Sets which sequence are used to
start a chain of Normal Sequences.
Seq.No S01 ~ S10 Sets the current sequence to edit.
Memo 12 characters A user-created note for the currently
selected sequence.
Mode CC, CR, CV, CP Operating mode for the sequence.
+CV mode is supported.
Range ILVL Low I range, Low V range
IMVL Middle I range, Low V range
IHVL High I range, Low V range
ILVH Low I range, High V range
IMVH Middle I range, High V range
IHVH High I range, High V range
Loop Infinite,
01 ~ 9999 Sets the amount of times to loop the
selected sequence.
Last Load OFF, ON Set the load condition after the end
of the sequence.
Last Value The setting value of the load for
when Last Load = ON.
Chain Off, S01~S10 Sets the next sequence in the chain,
when not set to off.