TEXIO LSG-1050H, Instruction Manual

Page: 140 / 205

130
4. EXTERNAL CONTROL
4-1.
Analog Control
The Analog Control subsection describes how to use the frame control ports
J1 for voltage or resistance control and the ports J3 for current/voltage monitor
output. The control ports J2, located under the frame
control ports J1 is used
for parallel control. See page 166 (
7-4.Frame Control Connector Contacts
) for the
details the frame control ports J1, J2 and J3.
4-1-1. The ports J1 /J3 Overview
4-1-1-1. The frame control ports J1
Description The J1 is a standard Mil 20 pin connector (OMRON XG4A
IDC plug). The connector is used for all analog control.
The pins are used to determine what mode is used.
See the appendix on page 166 to view the contact pin
assignment of the J1.
WARNING
Some pins on the frame control connector have the same
potential as the front and rear terminals.
To prevent electric shock, ensure the cover for both the
J1 and J2 connector.
Pin Assignment
FRAME CONT
J 1
1
2
19
20
J1 Pin assign
No Name No Name
1 Ext-V In / Ext-R In (+) 2 Ext-V In (+) for +CV
3 A COM 4 SUM I Mon Out
5 PRL In(+) 6 PRL In(-)
7 Ext-Load On(+) 8 I Rang)
9 I Rang) 10 Ext Alarm In(+)
11 Ext Trigger In(+) 12 A COM
13 Load On Out(+) 14 I Range S)
15 I Range S) 16 Alarm Out(+)
17 STATUS COM 18 NC
19 Short Signal Our(+) 20 Short Signal Our(-)