ENGINE REMOVAL AND INSTALLATION 5-7
• Install the engine sprocket
1
and snap ring
2
.
09900-06107: Snap ring remover (Open type)
• Reassemble the drive chain clip so the slit end faces opposite
the direction of rotation.
• Install the front chain guide plate
3
and engine sprocket
cover
4
.
• Tighten the engine sprocket cover bolts
5
to the specified
torque.
Engine sprocket cover bolt: 11 N·m (1.1 kgf-m, 8.0 lbf-ft)
• Install the gearshift lever
6
in the correct position.
* Replace the snap ring
2
with a new one.
* Seat the snap ring
2
in the groove and locate its end
as shown in the illustration.
Sharp
edge
Thrust
Direction of travel
When installing the front chain guide plate
3
, pay
attention to its direction.
Upper side
