4-8 MACHINE TUNING
SPRING CHANGE
• Remove the front forks. (
18-5)
• Thoroughly clean the fork before disassembly.
• Remove the fork cap bolt and drain fork oil. (
18-6)
• Loosen the center bolt completely. (
18-7)
• Compress the outer tube by hands and install the piston
holder (special tool) between the axle holder
1
and lock-nut
2
.
09910-20115: Piston holder
• Hold the lock-nut
2
with a wrench and remove the center bolt
3
.
• Remove the push rod. (
18-7)
• Remove the damper rod assembly and fork spring. (
18-8)
• Hold the front fork inverted position for more than 20 minutes
the allow the fork oil to fully drain. (
4-6)
• Force out the remaining oil using compressed air completely.
(
4-6)
• Replace the spring.
* The fork oil quantity must be adjusted equally on
both fork legs to provide equal performance.
* Scratches or other damage on the inner tube or on
the oil seal lip will cause oil leakage.
* Avoid scratching or damaging the inner tube or the
oil seal. Use a mild detergent or car wash soap and
sponge out dirt with plenty of water.
SPRING/No.
SPRING RATE
Identification
(Slit mark on
the spring end)
Soft
51171-28H10
4.5 N/mm
(0.45 kgf/mm)
(
4-7)
STD
51171-28H00
4.7 N/mm
(0.47 kgf/mm)
(
4-7)
Hard
51171-28H20
4.9 N/mm
(0.49 kgf/mm)
(
4-7)