PERIODIC MAINTENANCE 2-23
HOT STARTER
Adjust the hot starter cable play as follows:
NOTE:
Be careful not to damage the lever cover when installing.
(
20-28)
• Loosen the lock-nut
1
.
• Turn adjuster
2
so the hot starter lever clearance
A
mea-
sured at the lever holder obtains 2 –
3 mm (0.08 – 0.12 in)
when squeezing the lever until pressure is felt.
• Tighten the lock-nut
1
.
Hot starter lever clearance
A
: 2 – 3 mm (0.08 – 0.12 in)
Cable adjuster lock-nut: 2.2 N·m (0.22 kgf-m, 1.60 lbf-ft)
• Check that the hot starter lever moves smoothly from full open
to full close.
• If it does not move smoothly, lubricate the hot starter cable.
THROTTLE BODY
• Inspect the throttle body for dirt or mud. If any dirt or mud is
found, clean the throttle body.
