FI SYSTEM DIAGNOSIS 12-37
Step 1 (When indicating P0115-L:)
1) Stop the engine.
2) Check the ECT sensor coupler
1
for loose or poor contacts.
If OK, then measure the output voltage.
3) Remove the fuel tank. (
13-2, -3)
4) Disconnect the ECT sensor coupler and ECM coupler.
5) Insert the needle-pointed probes to the lead wire coupler.
6) Check the continuity between B/Bl wire
A
and ground.
If the sound is not heard from the tester, the circuit condition
is OK.
Tester knob indication: Continuity test (
)
7) Connect the ECT sensor coupler
1
and ECM coupler.
8) Insert the needle-pointed probe to the lead wire coupler.
9) Connect a 12 volts battery by using the battery lead wire to
the service coupler. (
12-19)
10)Measure the voltage between B/Bl wire and ground.
ECT sensor output voltage: 0.20 – 4.90 V
(
+
B/BI –
-
Ground)
09900-25008: Multi circuit tester set
09900-25009: Needle-pointed probe set
36890-28H00: Battery lead wire (option)
Tester knob indication: Voltage (
)
Are the continuity and voltage OK?
1
1
YES
Go to Step 2.
NO
• B/BI wire shorted to ground.
• If wire is OK, go to Step 2.
1
V