FUEL SYSTEM AND THROTTLE BODY 13-15
• Align the groove
F
of hot starter valve with the hot starter
cable end
G
.
INSTALLATION
Install the throttle body assembly in the reverse order of
removal. Pay attention to the following points:
• Connect the throttle pulling cable
1
and throttle returning
cable
2
to the pulley.
• Turn in each throttle cable adjuster fully and locate each outer
cable so that the clearance
a
is 0 – 1.5 mm (0 – 0.06 in).
• Tighten each lock-nut
3
to the specified torque.
Cable adjuster lock-nut: 2.2 N·m (0.22 kgf-m, 1.60 lbf-ft)
a
0 – 1.5 mm (0 – 0.06 in)
• Fit the projection
A
on the throttle body in the depression of
the intake pipe.
• Position the throttle body clamps
4
correctly. (
20-22)
• Install the condenser
5
.
INSPECTION AFTER INSTALLATION
• Wiring harness, cable and hose routing (
20-18 to -23)
• Fuel leakage
• Throttle cable play (
2-21)
• Engine idle speed (
2-24)
• TP sensor setting condition (
12-18)
