13-14 FUEL SYSTEM AND THROTTLE BODY
• Apply thin coat of the engine oil to the new O-ring
0
.
• Install the fuel delivery pipe
A
to the fuel pipe
8
.
• Tighten the fuel delivery pipe mounting screw
B
to the speci-
fied torque.
Fuel delivery pipe mounting screw:
3.5 N·m (0.35 kgf-m, 2.5 lbf-ft)
• Apply thin coat of the engine oil to the O-ring
C
.
• With the throttle valve fully closed, install the TP sensor
D
and tighten the TP sensor mounting screw to the specified
torque.
NOTE:
* Align the throttle shaft end
C
with the groove
D
of TP sensor.
* Apply grease to the throttle shaft end
C
if necessary.
99000-25010: SUZUKI SUPER GREASE “A”
or equivalent
09930-11950: Torx wrench (T25H)
TP sensor mounting screw: 3.5 N·m (0.35 kgf-m, 2.5 lbf-ft)
NOTE:
* Make sure the throttle valve open or close smoothly.
* TP sensor setting procedure. (
12-18)
• Connect the Yellow button
E
side of the fuel hose
E
to the
throttle body side.
• Install the starter knob/idle screw
F
to the lower hole.
Replace the O-ring
0
with a new one.
Never turn the fuel delivery pipe while pushing it.
Replace the O-ring with a new one.
Be sure to connect the fuel hose
E
by your hand. You
may not connect the fuel hose with any tool.
