SERVICING INFORMATION 20-19
*5
*9
*4
*6
*7
*3
*2
*1
*8
1
Ignition coil/plug cap
*2
Bind the regulator/rectifier lead wire and magneto lead
wire with the clamp. Set the tip of the clamp inside.
2
TP sensor lead wire
*3 The coupler of ignition coil/plug cap faces backward.
3
Condenser lead wire
*4
Clamp the wiring harness at the gray taping. Set the
tip of the clamp inside.
4
Breather hose
*5
Bind the ECT sensor lead wire, condenser lead wire
and TP sensor lead wire with the clamp. Set the tip of
clamp downward.
5
Engine stop switch lead wire
*6
Pass the service coupler lead wire inside of the
bracket.
6
GP switch lead wire
*7
Tighten coupler bracket bolt together with earth
branch wire of harness. Caulk the end of earth termi-
nal. (Bend flat part of earth terminal toward vehicle.)
a
90° – 110°
*8 Bend the clamp twice.
*1
Place engine stop switch lead wire on hot
starter cable and bind them together with
the clamp. Set the tip of the clamp left side.
*9
Bind the ECT sensor lead wires, condenser lead wire
and TP sensor lead wire with the clamp. Set the tip of
clamp backward inside.
