Suzuki GRAND VITARA JB416, Service Manual

Page: 445 / 474

Immobilizer Control System: 10C-7
8 Check for short of wire circuits between steering lock
unit and keyless start control module
1) Measure resistance at the following connector terminals.
• Between “G22-3”, “G22-7” and “G22-8” terminal of
steering lock unit connector.
• Between “G42-20”, “G42-29” and “G42-30” terminal of
keyless start control module.
Is each resistance infinity?
Go to Step 9. Make sure of insulation
of each wire circuit.
9 Check for short to ground wire circuit in wire circuits
between steering lock unit and keyless start control
module
1) Measure resistance at the following connector terminals.
• Between “G22-3” terminal of steering lock unit
connector and vehicle body ground.
• Between “G22-7” terminal of steering lock unit
connector and vehicle body ground.
• Between “G22-8” terminal of steering lock unit
connector and vehicle body ground.
• Between “G42-20” terminal of keyless start control
module connector and vehicle body ground.
• Between “G42-29” terminal of keyless start control
module connector and vehicle body ground.
• Between “G42-30” terminal of keyless start control
module connector and vehicle body ground.
Is each resistance infinity?
Go to Step 10. Repair short to ground
wire circuit in
malfunctional wire
circuit.
10 Check for short to power supply wire circuit in wire
circuits between steering lock unit and keyless start
control module
1) Measure voltage at the following connector terminals
with ignition switch turned ON.
• Between “G22-3” terminal of steering lock unit
connector and vehicle body ground.
• Between “G22-7” terminal of steering lock unit
connector and vehicle body ground.
• Between “G22-8” terminal of steering lock unit
connector and vehicle body ground.
• Between “G42-20” terminal of keyless start control
module connector and vehicle body ground.
• Between “G42-29” terminal of keyless start control
module connector and vehicle body ground.
• Between “G42-30” terminal of keyless start control
module connector and vehicle body ground.
Is each voltage 0 – 1 V?
Replace keyless start
control module with a
known-good one and
recheck. If DTC P1615
is still detected, replace
ECM with a known-good
one and recheck. Repair short to power
supply wire circuit in
malfunctional wire
circuit.
Step Action Yes No