Suzuki GRAND VITARA JB416, Service Manual

Page: 350 / 474

5A-31 Automatic Transmission/Transaxle:
Connector “E93”
Terminal Wire color Circuit
Standard
voltage
Condition
1 RED
Transmission range
sensor (“R” range)
8 – 14 V Ignition switch ON, selector lever at “R” range
0 – 1 V
Ignition switch ON, selector lever at other than “R”
range
2 — — — —
3 — — — —
4 PNK/WHT
4L/N switch (if
equipped) 8 – 14 V Ignition switch ON, transfer position in 4H
0 – 1 V Ignition switch OFF, transfer position in 4L and N
5 WHT
Output shaft speed
sensor (+)
0 – 1 V Ignition switch ON, engine stops
*(“Referenc
e Waveform
No. 4: ”)
While engine running.
(Output signal is waveform. Waveform frequency varies
depending on output shaft speed. (18 pulses are
generated par 1 input shaft revolution.))
6 BLU
Input shaft speed
sensor (+)
0 – 1 V Ignition switch ON, engine stops.
*(“Referenc
e Waveform
No. 5: ”)
While engine running.
(Output signal is waveform. Waveform frequency varies
depending on output shaft speed. (24 pulses are
generated par 1 input shaft revolution.))
7 GRN
Transmission range
sensor (“D” range)
8 – 14 V Ignition switch ON, selector lever at “D” range
0 – 1 V
Ignition switch ON, selector lever at other than “D”
range
8 GRN/ORN
Transmission range
sensor (“N” range)
8 – 14 V Ignition switch ON, selector lever at “N” range
0 – 1 V
Ignition switch ON, selector lever at other than “N”
range
9 — — — —
10 — — — —
11 — — — —
12 PNK/BLK Diagnosis switch 8 – 14 V Ignition switch ON
13 — — — —
14 ORN
Output shaft speed
sensor (–)
2 – 3 V Ignition switch ON, engine at stop
15 — — — —
16 PNK
Input shaft speed
sensor (–)
2 – 3 V Ignition switch ON, engine at stop
17 — — — —
18 GRN/WHT
Transmission range
sensor (“L” range)
8 – 14 V Ignition switch ON, selector lever at “L” range
0 – 1 V
Ignition switch ON, selector lever at other than “L”
range
19 GRN/ORN
Transmission range
sensor (“2” range)
8 – 14 V Ignition switch ON, selector lever at “2” range
0 – 1 V
Ignition switch ON, selector lever at other than “2”
range
20 PNK
Transmission range
sensor (“P” range)
8 – 14 V Ignition switch ON, selector lever at “P” range
0 – 1 V
Ignition switch ON, selector lever at other than “P”
range
21 — — — —
22 — — — —
23 PPL/WHT Data link connector 8 – 14 V Ignition switch ON
24 — — — —
25 — — — —
26 — — — —