Suzuki GRAND VITARA JB416, Service Manual

Page: 362 / 474

5A-43 Automatic Transmission/Transaxle:
47) Install adapter case (1) with new adapter gasket to
transmission case and tighten adapter case bolts to
specified torque.
Tightening torque
Adapter case bolt (a): 31 N·m (3.1 kgf-m, 30.0 lb-
ft)
48) Apply A/T fluid to new O-rings and install them to
input shaft speed sensor (1) and output shaft speed
sensor (2), and then install input shaft speed sensor
(1) and output shaft speed sensor (2).
49) After turning manual shift shaft fully rearward, turn it
back by 2 notches and set it to “N” range. Then
install shift switch, lock washer and nut and tighten
nut. After tightening it, bend claws of lock washer.
Tightening torque
Manual shift shaft nut (a): 12.5 N·m (1.25 kgf-m,
9.0 lb-ft)
50) With neutral reference line (1) and cut groove (2) in
switch aligned, tighten lock bolt.
Tightening torque
Transmission range sensor bolt (b): 5.3 N·m (
0.53 kgf-m, 4.0 lb-ft)
51) Confirm that torque converter is fully fitted in
transmission. Confirmation can be done by
measuring dimension between end surface of
housing case (2) and drive plate installation seat.
Standard dimension between end surface of
case housing and drive plate installation seat “a”
17.4 mm (0.69 in.)
52) Check that torque converter turns smoothly and
apply grease to center piece (1) of torque converter.
1
(a)
(a)
I5JB0A510145-01
1
2
I5JB0A510163-01
(b)
1
2
(a)
I5JB0A510147-01
IYSQ01510279-01