AXDIS-CL2
I N S TA L L AT I O N I N S T R U C T I O N S
AxxessInterfaces.com
© COPYRIGHT 2020 METRA ELECTRONICS CORPORATION
REV. 1/21/20 INSTAXDIS-CL2
INTERFACE FEATURES
INTERFACE COMPONENTS
TOOLS REQUIRED
• Wire cutter • Crimp tool • Solder gun • Tape • Connectors (example: butt-connectors, bell caps, etc.) • Small flat-blade screwdriver
TABLE OF CONTENTS
Connections ........................................................ 3-6
- For models
without
an amplifier .......................3
- For models
with
an analog amplifier ................4
- For models
with
a digital amplifier ...................5
- 3.5mm jack steering wheel control retention ..6
Installation .............................................................6
Programming ...........................................................6-7
Adjustments ...........................................................8
Extra features .....................................................8-9
Steering wheel control settings ......................9-12
- L.E.D. feedback ....................................................9
- Changing radio type ......................................... 10
- Remapping ...............................................................10
- Dual assignment instructions .................................11-12
Troubleshooting ....................................................12
GM
Data Interface with SWC 2000-2013
APPLICATIONS
See inside front cover
• Provides accessory power
(12-volt 10-amp)
• Retains R.A.P. (retained
accessory power)
• Provides NAV outputs (parking
brake, reverse, speed sense)
• Retains chimes
• Retains audio controls on the
steering wheel
• Retains OnStar / OE Bluetooth
• Adjustable OnStar level
• Retains the factory AUX-IN jack
• Retains RSE (rear seat
entertainment) *
• Retains SAT (satellite radio)
• Can be used in non-amplified,
or analog/digital amplified
models
• Retains balance and fade
(excludes digital amplified
models)
• Micro “B” USB updatable
• AXDIS-CL2 interface • AXDIS-CL2 harness
• 16-pin harness with stripped leads • 4-pin harness with stripped leads
• Female 3.5mm connector with stripped leads
* The RSE must be activated by the factory radio
