4
CONNECTIONS TO BE MADE
(CONT)
The following (3) wires are only for multimedia/navigation radios that require these wires.
• Connect the
Blue/Pink
wire to the VSS/speed sense wire.
Note:
There are (2) speed sense wires. If the Blue/Pink wire on the AXDIS-CL2 harness is
populated on the factory side, use that wire instead.
• Connect thTe
Green/Purple
wire to the reverse wire.
• Connect the
Light Green
wire to the parking brake wire
• Tape off and disregard the following (4) wires, they will not be used in this application:
Green
,
Green/Black
,
Purple
,
Purple/Black
From the AXDIS-CL2 harness to the aftermarket radio:
• Connect the
Black
wire to the ground wire.
• Connect the
Yellow
wire to the battery wire.
• Connect the
Green
wire to the left rear positive speaker output.
• Connect the
Green/Black
wire to the left rear negative speaker output.
• Connect the
Purple
wire to the right rear positive speaker output.
• Connect the
Purple/Black
wire to the right rear negative speaker output.
• Disconnect the (2) 4-pin Molex connectors and then attach the 4-pin to 4-pin resistor pad harness.
The following (1) wire is only for a multimedia/navigation radio that requires this wire.
• If the
Blue/Pink
wire is populated on the factory side, connect this wire to the VSS/speed sense wire
.
• The
Black/Yellow
wire is used for OnStar level adjustment for models that do not come equipped
with steering wheel controls. Refer to the OnStar level Adjustment section for further instructions.
• Connect the
Red
and
White
RCA jacks to the audio AUX-IN jacks of the aftermarket radio.
• The DIN jack is to be used with the optional AX-LCD (sold separately).
• Connect the
Red
wire to accessory power.
Continue to 3.5mm jack steering wheel control retention
Attention!
This interface will work with models that are either non-amplified, analog ampli-
fied, or digital amplified. Please follow the instructions carefully for your model vehicle. Failure
to do so will result in either no sound, or low sound. If you are unsure if your vehicle is factory
amplified or not, please contact your local dealership.
For models
with
an analog amplifier:
From the 16-pin harness with stripped leads to the aftermarket radio:
• Connect the
Red
wire to the accessory wire.
Note:
If installing an AX-LCD (sold separately), there will be an accessory wire there to
connect as well.
• Connect the
Blue/White
wire to the amp turn on wire. This wire must be connected to hear
sound from the factory amplifier.
• If the aftermarket radio has an illumination wire, connect the
Orange/White
wire to it.
• If the aftermarket radio has a mute wire, connect the
Brown
wire to it. If the mute wire is
not connected, the radio will turn off when OnStar is activated.
• Connect the
Gray
wire to the right front positive speaker output.
• Connect the
Gray/Black
wire to the right front negative speaker output.
• Connect the
White
wire to the left front positive speaker output.
• Connect the
White/Black
wire to the left front negative speaker output.
