117:
Only for internal Siemens use
150:
Wait until Power Module is determined
160:
Evaluate Power Module
170:
Instantiate Control Unit reset
180:
Only for internal Siemens use
200:
First commissioning
210:
Create drive packages
250:
Wait for fault acknowledge
325:
Wait for input of drive type
350:
Determine drive type
360:
Only for internal Siemens use
370:
Wait until p0010 is set to 0
380:
Only for internal Siemens use
550:
Call conversion functions for parameter
625:
Wait for non-cyclic start
650:
Start cyclic operation
660:
Evaluate drive commissioning status
670:
Only for internal Siemens use
680:
Only for internal Siemens use
690:
Wait for non-cyclic start
700:
Save parameters
725:
Wait for cyclic
740:
Check the ability to operate
745:
Start cyclic calculations
750:
Interrupt enable
800:
Initialization finished
Index:
[0] = System
[1] = Partial boot
r3996[0...1]
Parameter write inhibit status / Par_write inhib st
Access level: 3
Calculated: -
Data type: Unsigned8
Can be changed: -
Scaling: -
Dynamic index: -
Unit group: -
Unit selection: -
Function diagram: -
Min:
-
Max:
-
Factory setting:
-
Description:
Displays whether writing to parameters is inhibited.
r3996[0] = 0:
Parameter write not inhibited.
0 < r3996[0] < 100:
Parameter write inhibited. The value shows how the calculations are progressing.
Index:
[0] = Progress calculations
[1] = Cause
Note
For index 1:
Only for internal Siemens troubleshooting.
Parameters
7.2 Parameter list
SINAMICS G120X converter
852
Operating Instructions, 06/2019, FW V1.01, A5E44751209B AC
