Note
Re-parameterization is also possible if a fault is present. The change only becomes effective after the fault has been
resolved.
The acknowledge mode can only be changed for faults with the appropriate identification.
Example:
F12345 and acknowledge mode = IMMEDIATELY (POWER ON)
--> The acknowledge mode can be changed from IMMEDIATELY to POWER ON.
p2128[0...15]
Faults/alarms trigger selection / F/A trigger sel
Access level: 3
Calculated: -
Data type: Unsigned16
Can be changed: T, U
Scaling: -
Dynamic index: -
Unit group: -
Unit selection: -
Function diagram: 8050, 8070
Min:
0
Max:
65535
Factory setting:
0
Description:
Sets the faults/alarms for which a trigger signal should be generated in r2129.0...15.
Dependency:
If the fault/alarm set in p2128[0...15] occurs, then the particular binector output r2129.0...15 is set.
See also: r2129
r2129.0...15
CO/BO: Faults/alarms trigger word / F/A trigger word
Access level: 3
Calculated: -
Data type: Unsigned16
Can be changed: -
Scaling: -
Dynamic index: -
Unit group: -
Unit selection: -
Function diagram: 8070
Min:
-
Max:
-
Factory setting:
-
Description:
Display and BICO output for the trigger signals of the faults/alarms set in p2128[0...15].
Bit field:
Bit
Signal name
1 signal
0 signal
FP
00
Trigger signal p2128[0]
ON
OFF
-
01
Trigger signal p2128[1]
ON
OFF
-
02
Trigger signal p2128[2]
ON
OFF
-
03
Trigger signal p2128[3]
ON
OFF
-
04
Trigger signal p2128[4]
ON
OFF
-
05
Trigger signal p2128[5]
ON
OFF
-
06
Trigger signal p2128[6]
ON
OFF
-
07
Trigger signal p2128[7]
ON
OFF
-
08
Trigger signal p2128[8]
ON
OFF
-
09
Trigger signal p2128[9]
ON
OFF
-
10
Trigger signal p2128[10]
ON
OFF
-
11
Trigger signal p2128[11]
ON
OFF
-
12
Trigger signal p2128[12]
ON
OFF
-
13
Trigger signal p2128[13]
ON
OFF
-
14
Trigger signal p2128[14]
ON
OFF
-
15
Trigger signal p2128[15]
ON
OFF
-
Dependency:
If the fault/alarm set in p2128[0...15] occurs, then the particular binector output r2129.0...15 is set.
See also: p2128
Note
CO: r2129 = 0 --> None of the selected messages has occurred.
CO: r2129 > 0 --> At least one of the selected messages has occurred.
Parameters
7.2 Parameter list
SINAMICS G120X converter
Operating Instructions, 06/2019, FW V1.01, A5E44751209B AC
773
