r1205.0...20
CO/BO: Flying restart vector control status / FlyRest vector st
G120X_DP (PM330),
G120X_PN (PM330),
G120X_USS (PM330)
Access level: 4
Calculated: -
Data type: Unsigned32
Can be changed: -
Scaling: -
Dynamic index: -
Unit group: -
Unit selection: -
Function diagram: -
Min:
-
Max:
-
Factory setting:
-
Description:
Display and connector output for the status for checking and monitoring flying restart states in the vector control mode.
Bit field:
Bit
Signal name
1 signal
0 signal
FP
00
Speed adaptation circuit record angle
Yes
No
-
01
Speed adaptation circuit set gain to 0
Yes
No
-
02
Isd channel enable
Yes
No
-
03
Speed control switched out
Yes
No
-
04
Quadrature arm switched in
Yes
No
-
05
Special transformation active
Yes
No
-
06
Speed adaptation circuit set I component to 0
Yes
No
-
07
Current control on
Yes
No
-
08
Isd_set = 0 A
Yes
No
-
09
Frequency held
Yes
No
-
10
Search in the positive direction
Yes
No
-
11
Search Started
Yes
No
-
12
Current impressed
Yes
No
-
13
Search interrupted
Yes
No
-
14
Speed adaptation circuit deviation = 0
Yes
No
-
15
Speed control activated
Yes
No
-
16
Fast flying restart w/ voltage model for induction motor activ. Yes
No
-
17
Fast flying restart w/ voltage model for induction motor exited Yes
No
-
18
Apply VSM voltage to the monitor
Yes
No
-
19
Preassign flux ramp
Yes
No
-
20
Adaptation current controller and speed adapt. controller gain Yes
No
-
Note
For bit 00 ... 09:
Used to control internal sequences during the flying restart.
Depending on the motor type (p0300), the number of active bits differs.
For bits 10 ... 15:
Are used to monitor the flying restart sequence.
p1206[0...9]
Automatic restart faults not active / AR fault not act
Access level: 3
Calculated: -
Data type: Unsigned16
Can be changed: T, U
Scaling: -
Dynamic index: -
Unit group: -
Unit selection: -
Function diagram: -
Min:
0
Max:
65535
Factory setting:
0
Description:
Sets faults for which automatic restart should not be effective.
Dependency:
The setting is only effective for p1210 = 6, 16, 26.
See also: p1210
Parameters
7.2 Parameter list
SINAMICS G120X converter
Operating Instructions, 06/2019, FW V1.01, A5E44751209B AC
647
