Shibaura CA20-M10, Operating Manual

Page: 339 / 384

18
– 39
PSEL
[Function] The status of the program No. selection input signal set with the mode setting
is judged, and the tag No. is jumped to according to the input state. (Refer to
section 10.2.9.)
[Explanation]

The program No. input signal is judged at the point the PSEL command is
executed.
[Key operation]
STEP 1
Press
F 1
, and then press
IN
1
and
RET
0
. NOP changes to PSEL.
Press
ENT
.
Refer to section 13.2.5 for details on the bit No. selection input bit designation.
During multitasking, if the PSEL command is input for multiple tasks and is executed,
the "NO TAG FOUND" error will occur. Jumping to a tag No. in another task is also not
possible.
[ P R G M ]
0 0 0 1
N O P
[ P R G M ]
0 0 0 1
P S E L
Program Selection
Program start
Program end Program end
The input status of the program No.
selection signal is judged, and the
designated tag No. is jumped to.
Program selection
PSEL
command
TAG command
END command
Tag No. = 8 setting Tag No. = 1 setting
Program 8 start Program 8 start