Shibaura CA20-M10, Operating Manual, Page: 335 / 384

18
– 35
OUT
[Function] The general-purpose output of the unit with the designated station No. is
turned ON or OFF.
[Explanation]

After execution, the output state is held until the next OUT command is
issued. Even if the END command is executed and the program ended, the
output signal will be held.

To turn OFF the output signal, set "0" at the output bit desired to be turned
OFF with OUT command, or turn OFF the power supply of the controller.

Whether to hold or clear (turn OFF) the general-purpose output signal in
the mode setting and continuous start signal state when the reset signal is
input can be selected. (Refer to sections 10.2.6 and 15.2.11.)

If the OUT command is set as shown below, the general-purpose output port
1 No. 1 (general-purpose output port 1-1) and No. 7 (general-purpose output
port 1-7) will turn ON and the general-purpose output port 1 No. 4
(general-purpose output port 1-4) and No. 5 (general-purpose output port
1-5) will turn OFF for the unit of which the station No. is set to "0". The
general-purpose output signal at the "
•" display section will hold the current
signal state.
(Example)
[Key operation]
Press
OUT
2
.
NOP changes to OUT.
Press
ENT
.
[ P R G M ]
0 0 0 1 P O R T 0 - 0 1
O U T ･ 1 ･ 0 0 ･ ･ 1
[ P R G M ]
0 0 0 1
N O P
General-purpose Port Output
"1" ---------- Output ON
"0" ---------- Output OFF
"
•" ---------- Hold current output state
Station No.
Port No.
No. 1
Output No. 8
STEP 1