Shibaura CA20-M10, Operating Manual, Page: 376 / 384

20
– 16

Connection terminal

Using the accessories
Accessory: Relay connector × 2
● Connector model
Plug 222-412
Manufacturer WAGO
● Wiring procedure

Raise the top lever by about 90°.

Insert the wire all the way inside.

Return the top lever to its original
position.

Gently pull on the wire to check
that it is connected correctly.
* Peel off about 9 mm of the wire
covering.
CAR-0500
Accessory: Connector, wire connection
lever
● Connector model
Plug
734-105
Wire connection lever 734-230
Manufacturer
WAGO
● Wiring procedure

Hook the supplied wire connection
lever as shown in the figure below.

Insert the wire all the way inside while
pressing the wire connection lever.
Downward as shown in the figure
below.

Return the wire connection lever to its
original position.

Gently pull on the wire to check that it
is connected correctly.
CAR-UN50
* The pins are connected
electrically inside the connector.
222-412



２３
１
４５
Pin numbers
* These are not displayed on the connector body.
734-230
734-105



CAR-0500
Bottom View
Resistor 1
Temperature relays 1 and
2
Resistor 2
* If the length of the output lines of the
temperature relay is not enough, use by
connecting the supplied relay connector.
* The wires should be provided by the customer
.
CAR-UN50
Front View
Pin No. Name
1 Resistor 1
2 Resistor 2
3 Temperature relay 1
4 Temperature relay 2
5 FG
* The wires should be provided by the customer.