Shibaura CA20-M10, Operating Manual, Page: 85 / 384

4
– 1
Chapter 4 Sequential Mode

4.1 Sequential PRGM mode
Sequential programs are structured of a command words written in as series of steps.

4.1.1 How to enter and leave PRGM (program) mode
The PRGM mode is used for programming, setting parameters, and for controlling direct
output. The method for entering and leaving the PRGM mode (sequential mode) will be
described in this section.
STEP 1
Turn the power ON. When the display shown at
left appears after the initial screen, press
F 1
.
Then press
RUN
PRGM
to enter PRGM mode.
Refer to section 5.3.2 (1) when the task must be
changed with multitasking.
STEP 2
A program can now be written. Press
NEXT
or
-NEXT
until the desired step is displayed. To set
parameters and edit the program, press
HELP
to display the screen in STEP 3.
When
RUN
PRGM
is pressed, the program editing
will end, and the AUTO mode will be entered.
STEP 3
From this step, it is possible to input the
extension command, control the direct output,
edit the program and set various parameters.
Press
ENT
to display the next screen.
Press
ESC
to return to STEP 2.