Shibaura CA20-M10, Operating Manual

Page: 124 / 384

6
– 12

End setting
In the easy mode, a setting to indicate the end of the operation at the final step of the series
of operations (including cycle operation) must be set regardless of the operation pattern.
For example, with an operation pattern of point A to point B to point C is carried out as
shown below, the step point C at the end of the cycle will be the end step.
[ E A S Y ] 0 1 X =
0 0 1 V = 0 0 Y =
T A G : 0 0 0
[ E A S Y ] 0 1 X =
0 0 2 V = 0 0 Y =
T A G : 0 0 0
[ E A S Y ] 0 1 X =
0 0 3 V = 0 0 Y =
T A G : 0 0 0
*
[ E A S Y ] 0 1 X = 0 0 0 0 . 0 0
0 0 4 V = 0 0 Y = 0 0 0 0 . 0 0
T A G : 0 0 0
Operation pattern
STEP 1
Display the end step screen and press
F 3
.
A "

" to indicate the end will display, and the
end setting will be completed.
To delete the end setting "

", press
F 3
again.
NOTE
Always set the end when using the easy mode. If the end is not set, a step No. error
will occur when the program is executed.
NEXT
key
NEXT
key
NEXT
key
Point A
Point C
Ｐｏｉｎｔ Ａ
ｃｏｏｒｄｉ
-
ｎａｔｅｓ
Ｐｏｉｎｔ Ｂ
ｃｏｏｒｄｉ
-
ｎａｔｅｓ
Ｐｏｉｎｔ Ｃ
ｃｏｏｒｄｉ
-
ｎａｔｅｓ
Point B