Muratec mfx-2200, User Manual

Page: 352 / 382

9-26
Error message Countermeasure
Reference
page
Please wait The machine is getting ready. Wait for a while until the
operation is available. —
Preparing The printer is not ready for printing. When it is ready
to print, the message will disappear. Please wait for a
while. —
Press [Stop] to exit the
doc. Scanning was canceled in the middle of the process due
to the memory overflow or by pressing <Stop>. Press
<Stop> to discharge all the documents. —
Printer In Use You tried to print a list etc. during printing. Wait until
the current printing ends. —
Ratio is set to 100% If you set the paper selection to auto when setting the
magnification to auto, the magnification will be set to
100%. —
Relay Box A box specified when you store, delete or print the
F-code document has been set as a relay box. 4-32,
4-34,
4-36
Replace drum cartridge The drum cartridge is empty. Replace with a new drum
cartridge. Be sure to replace with an unused drum
cartridge. If you replace with a used drum cartridge,
the error message will not disappear. 9-2
Rotate the document 90
deg or set the ratio Copying cannot be performed in the specified
document direction. Rotate document 90° or re-set the
magnification. —
Rx doc. Stored You tried to set the protect passcode for the security
reception to 0000 (cancel) when you received
documents. After printing all the received documents,
cancel the security reception. 6-16
Secure Box A box specified when you store or delete the F-code
document has been set as a security box. 4-32,
4-36
Secure Rx is canceled Documents received in the security reception were
printed.
After printing, the security reception settings will be
cancelled. 6-16
Set the document and
press [Start].
From Page : This message is displayed when no document remains
on the ADF after a document jam is released.
Load the documents from the page displayed, and
press <Start>. The following documents will be stored. 9-17
System stabilization is
needed. Turn power off
and on The system is unstable. Turn OFF the power switch,
and wait for three seconds or more before turning ON
again. If the same message appears again, contact your
authorized Muratec dealer. —
The value exceeds limit.
Enter a value within
range. A wrong number was entered.
Enter the correct value. —
Toner is almost empty. The toner becomes low. Get a new toner cartridge
ready. 9-2
Toner is empty Toner ran out. Replace the toner cartridge. 9-2
DB2-90290-60.indb 26 2007/02/02 12:34:25