ID
Index Name
Unit Description
2865
HYD_TabNextIdx
2865
0. . 15 HYD_TabNextIdx
Hydraulic table next default index
Table 7.76: Parameter “Hydraulic table next default index”
Subsequent motion block Event Ctrl
If the transition switching condition P 2867 - Hyd_TabCondType is true, a switchover
is made to the motion block specified here.
ID
Index Name
Unit Description
2866
HYD_TabAltIdx
2866
0. . 15 HYD_TabAltIdx
Hydraulic table next alternative index
Table 7.77: Parameter “Hydraulic table next alternative index”
NOTE
l
If a subsequent motion block and an alternative motion block are
entered, the branch always leads to the motion block for which the
condition is met first.
Switching condition
There are two different modes to choose from for the transition switching to the next
motion block.
ID
Index Name
Unit Description
2867
HYD_TabCondType
2867
0. . 15 HYD_TabCondType
Hydraulic table state
Table 7.78: Parameter “Hydraulic table state”
Optional comparison value
Comparison value for the transition switching condition (ConAddr)
MOOG
ID No.: CB40859-001 Date: 11/2020
MSD Servo Drive - Device Help
196
7 Control
ID
Index Name
Unit Description
2868
HYD_TabCondVal
2868
0. . 15 HYD_TabCondVal
Hydraulic table comparison state
Table 7.79: Parameter “Hydraulic table comparison state”
7.11.7 Pressure control
The pressure is controlled by a PI pressure controller using P 2850 - HYD_PressCon
based on the pressure setpoint. Here you can choose between two controller
structures using P 2840 [16] AltPressCon. The selection PressCon_nPump(0)
outputs a pump speed at the output of the controller which is directly forwarded to
the speed controller (see Image 7.67: Mask of pressure control with pump speed
output). The selection PressCon_VolFlow(2) has a volumetric flow rate output in
l/min and an underlying volume flow control which takes the displacement volume of
the pump into account (see Image 7.68: Mask of pressure control with volumetric
flow rate output.). This can be helpful for pumps with a variable displacement
volume, as this means the control circuit gain remains unchanged and the controller
parameters do not need to be adjusted. If during operation of the pressure control
one of the specified limit values P 2850 [7] - Qmin or P 2850 [8] - Qmax is reached
due to the pump speed, the actuating variable (motor speed) is limited accordingly.
Moreover, the configured speed limits (P 2851.5 nMin, P2851.6 nMax) for the pump
always take priority. In addition, it is possible to set the minimum and maximum
system pressure via a pressure limitation. To take into account the different area
ratio of a differential cylinder, the actual pressure values can be scaled to the
respective area ratio using UnitScale_pAct and UnitScale_pAct2 (P 2850.12
pActScale, P 2850.13 pAct2Scale).
For control systems with high dynamic performance, it may be necessary to take into
account a pressure-dependent compressibility in the control system. This
compressibility will decrease as the pressure increases, i.e. less fluid needs to be
