Mitsubishi Electric MELSERVO-J4 series, Instruction Manual

Page: 464 / 646

462
13 USING STO FUNCTION
13.3 Connection example
External I/O signal connection example using an external safety
relay unit
This connection is for source interface. For the other I/O signals, refer to the connection examples in the
following section.

Page 97 For source I/O interface
This connection example complies with the requirement of ISO/EN ISO 13849-1 category 3 PL d.
For details, refer to the safety relay module user’s manual.
*1 To enable the STO function of the servo amplifier by using "Emergency switching off", change S1 to EMG. The stop category at this time
is "0". If STO is turned off while the servo motor is rotating, [AL. 63 STO timing error] will occur.
K3
K3
CN8
KM1
CN3
20
STO1
TOFB1
TOFCOM
TOFB2
STO2
STOCOM
M
KM1
KM1
EMG S4
S3
Safety relay
module
MELSEC
(QS90SR2S)
Fuse
24 V
0 V
S2
S1 or
EMG *1
Control
circuit
Power
supply
S1: STO shut-off switch (STO switch)
S2: Start switch (STO release switch)
S3: On switch
S4: Off switch
KM1: Magnetic contactor
K3: Safety relay
EMG: Emergency stop switch
+24V XS0 XS1 Z00 Z10 Z20
X0
COM0
24G X1
COM1
Z01 Z11 Z21
EM1
or
EM2
Control circuit
Servo amplifier
Servo motor