246
6 NORMAL GAIN ADJUSTMENT
6.5 2 gain adjustment mode
Adjustment procedure of 2 gain adjustment mode
Set the same value in [Pr. PB07 Model loop gain] for the axis used in 2 gain adjustment mode.
Parameter adjustment
[Pr. PB07 Model loop gain]
This parameter determines the response level of the position control loop. Increasing the value improves trackability to a
position command, but a too high value will make overshoot liable to occur at settling. The droop pulses value is determined
by the following expression.
Position command frequency differs depending on the operation mode.
Rotary servo motor and direct drive motor:
Linear servo motor:
Position command frequency = Speed [mm/s]
Encoder resolution (travel distance per pulse)
Step
Operation
Description
1
Set to the auto tuning mode.
Select the auto tuning mode 1.
2
During operation, increase the response level setting value in [Pr. PA09], and return the setting if
vibration occurs.
Adjustment in auto tuning mode 1
3
Check value of the model loop gain and the load to motor inertia ratio in advance.
Check the upper setting limits.
4
Set the 2 gain adjustment mode 1 ([Pr. PA08]: _ _ _ 0).
Select the 2 gain adjustment mode 1
(interpolation mode).
5
When the load to motor inertia ratio is different from the design value, select the 2 gain adjustment
mode 2 ([Pr. PA08]: _ _ _ 4) and then set the load to motor inertia ratio manually in [Pr. PB06].
Check the load to motor inertia ratio.
6
Set the model loop gain of all the axes to be interpolated to the same value. At that time, adjust to the
setting value of the axis, which has the smallest model loop gain.
Set model loop gain.
7
Considering the interpolation characteristic and motor status, fine-adjust the model loop gain and
response level setting.
Fine adjustment
Model loop gain setting
Position command frequency [pulse/s]
Number of droop pulses [pulse] =
Servo motor speed [r/min]
60
=
Position command frequency
× Encoder resolution (number of pulses per servo motor revolution)
Summary of Contents for MELSERVO-J4 series
Page 2: ......
Page 605: ...APPX Appendix 6 EC declaration of conformity 603 A ...
Page 638: ...636 APPX Appendix 14 Encoder output pulse setting method MEMO ...
Page 645: ......
