Mitel Inter-Tel 5000, Installation And Maintenance Manual

Page: 236 / 468

Chapter 5: Installation
Axxess IP PhonePlus
Page 5-114
Inter-Tel
®
5000 Installation Manual – Issue 2.4, May 2008
Axxess IP PhonePlus
To wall-mount the Axxess IP PhonePlus:
1. Remove the baseplate from the top half of the back of the endpoint.
2. Carefully unplug the ribbon cable.
3. On the back of the endpoint, use a pair of
cutting pliers to remove the plastic knockout
covering the lower connector on the endpoint
control board.
4. Plug the free end of the ribbon cable into the
connector on the endpoint control board
(where the plastic knockout was previously
removed).
5. Use a pencil (eraser end) or other suitable rod-
like instrument to press each end of the cable
into the connector. Apply pressure until the
connector clicks securely into place, one end
at a time.
6. Rotate the baseplate 180º and attach it to the bottom half of the back of the endpoint.
7. Using a ruler, mark the location of the endpoint mounting holes on the wall. (The centers
of the two perpendicular mounting holes on the back of the endpoint are four inches
apart.)
8. Drive a screw into the center of each mounting
hole marking. Allow the head of the screw to
protrude approximately ¼ inch.
9. To hold the handset in place while the endpoint
is wall-mounted, slide the reversible cradle
hook out, rotate it 180º, and reinsert it as
shown on the right.
10. Position the endpoint mounting holes over the
screws and slide the endpoint into position on
the wall. If necessary, adjust the screws to
ensure the endpoint is held firmly in place.
NOTE
Be careful not to let the plastic
knockout fall inside the endpoint. If
the knockout falls inside the
endpoint, do
not remove it.
Remove this knockout to
access the connector on
the control board.
Remove the ribbon
cable from this con-
nector.
Back