![Mitel Inter-Tel 5000 Installation And Maintenance Manual Download Page 168](http://html.mh-extra.com/html/mitel/inter-tel-5000/inter-tel-5000_installation-and-maintenance-manual_1807155168.webp)
Chapter 5: Installation
Installing a Single-Port T1/E1/PRI Module (T1M)
Page 5-46
Inter-Tel
®
5000 Installation Manual – Issue 2.4, May 2008
Installing a Single-Port T1/E1/PRI Module (T1M)
See Figure 5-22 on
page 5-46
for an illustration of this module and for the following procedure.
To install a T1M module:
1.
Using a properly terminated, anti-static wrist strap, remove the module from the
protective anti-static bag.
2.
Insert the module carefully so that it aligns with the rails inside the chassis, then gently
slide the module into the chassis until it stops and the module release lever clicks into
place (up position). Do not use force.
3.
Tighten the fastener at the top of the module, securing the module to the chassis. Do not
over tighten this fastener.
4.
If not adding any other modules, continue to “Installing the USB Security Key and Inter-
Tel Memory Card” on
page 5-19
.
Figure 5-22.
T1M Module
To remove a T1M module:
1.
Using a properly terminated, anti-static wrist strap, loosen the fastener at the top of the
module (this fastener secures the module to the chassis).
2.
Push down and hold the module release lever, then when the
REMOVE
LED turns
green, grasp the module handle and carefully remove the module from the chassis.
IMPORTANT
The T1M module can be removed with power on; however, you must wait for
the REMOVE LED indicator to change to green before removing the module.
Pressing and holding the release lever until the LED indicator turns green
allows the software to “disconnect” from the module. Failure to wait until the
LED turns green, could result in pending information getting lost or
unexpected system behavior.
Other than the processor module, all other modules can reside in any bay.
However, DB Programming will need to change, if you move a module (that
was previously programmed) into a different bay location.
Processor Module
Base Server Back
T1M Module
Module Release Lever
Module-to-Chassis Fastener
Remove
Module LED
DUAL LS DUAL SL
EXP
PAGE
MOH
Summary of Contents for Inter-Tel 5000
