Mindray BeneView T1, Operator'S Manual

Page: 41 / 286

3-3
3.2.2 Starting Monitoring
1. Decide which measurements you want to make.
2. Check that the patient cables and sensors are correctly connected.
3. Check that the patient settings such as [ Patient Cat. ], [ Paced ], etc, are appropriate for your patient.
Refer to the appropriate measurement section for details of how to perform the measurements you require.
3.3 Turning off the Monitor
Before turning off the monitor,
1. Confirm that the patient monitoring is finished.
2. Disconnect patient cables and sensors from the patient.
3. Make sure to save or clear the patient monitoring data as required.
Then press and hold the power on/off switch to turn off the monitor.
CAUTION

Although not recommended, you can press and hold the power on/off switch for ten seconds to forcibly
shut down the monitor when it could not be shut down normally or under some special situations. This
may cause loss of data of the patient monitor.
NOTE

To completely disconnect the power supply, unplug the power cord.
3.4 Using the Touchscreen
You can select screen items by touching them directly on the patient monitor’s screen.
To avoid misoperation, you can lock the touchscreen. If the touchscreen is locked, a message [ Screen locked. Please
move the lock/unlock key to unlock the screen ] is shown. The touchscreen is locked automatically if no operation is
detected within 60 seconds.
If the screen is locked, sliding the lock/unlock key to the right can unlock the screen.
3.5 Using the On-screen Keyboard
The onscreen keyboard enables you to enter information.

Use the key to delete the previously entered character.

Use the key to toggle between uppercase and lowercase letters.