Mindray BeneView T1, Operator'S Manual

Page: 199 / 286

20-5
20.4.8 Certificates Maintenance
You can import or delete the monitor’s certificates.
1. Select [ Main Menu ]
→
[ Maintenance>> ]
→
[ User Maintenance>> ]
→
enter the required password
→
[ Network
Setup >> ]
→
[ Certificates Maintenance >> ].
2. Select [Import certificates] or [Delete certificates].
20.4.9 Setting the Multicast Parameters
Whether the equipment is presented by broadcast or multicast is defined before the equipment leaves the factory. If
[ Multicast ] is selected, you need to set the multicast parameters.
To do so,
1 Select [ Main Menu ]
→
[ Maintenance>> ]
→
[ User Maintenance>> ]
→
enter the required password
→
[ Network
Setup >> ]
→
[ Multicast Setup >> ].
2. Set [ Multicast Addr ] and [ TTL ].
20.4.10 Connecting the monitor to the CMS
To connect the monitor to the CMS, proceed as follows:
1 Select [ Main Menu ]
→
[ Maintenance>> ]
→
[ User Maintenance>> ]
→
enter the required password
→
[ Network
Setup >> ]
→
[ Monitor Network Setup >> ].
2. In the [ Monitor Network Setup ] menu, set [ Network Type ] and [ Address Type ].
3. Input the monitor IP address, subnet mask and gateway address if the [ Address Type ] is set to [ Manual ]
4. Connect the monitor to the CMS through either of the following methods:

Admit the monitor on the CMS. Refer to the Hypervisor VI Operator's Manual (PN: H-300B-20-47610) for details of
admitting a monitor.

Setting the CMS (refer to section 20.4.10.1 Setting the
CMS
for details), and then selecting a CMS (refer to section
20.4.10.2 Selecting a CMS for details).
20.4.10.1 Setting the CMS
You can configure up to 30 central stations (CMS) for your monitor. To set the CMSs,
1 Select [ Main Menu ]
→
[ Maintenance>> ]
→
[ User Maintenance>> ]
→
enter the required password.
→
[ Network
Setup >> ].
2. Set [ Select CMS ] to [ On ].
3. Select [ Central Station Setup >> ].
4. Set CMS names and corresponding IP addresses.