Mindray BeneView T1, Operator'S Manual

Page: 156 / 286

15-4
NOTE

To extend the lifetime of the watertrap and module, disconnect the watertrap and set the operating mode
to standby mode when CO
2
monitoring is not required.
15.3.2 Using a Microstream CO
2
Module
Connect the sampling line to the module and then connect the CO
2
components as shown below. The message [ CO2
Sensor Warmup ] is displayed. After warm-up, you can perform CO
2
measurements. The message [ CO2 Sensor Warmup ]
is displayed.
15.3.3 Using a Mainstream CO
2
Module
1. Connect the sensor to the module. The message [ CO2 Sensor Warmup ] is displayed.
2. After warm-up is finished, connect the transducer to the airway adapter.
3. Perform a zero calibration per 15.9 Zeroing the Sensor .
4. After the zero calibration is finished, connect the airway as shown below.
5. Make sure there are no leakages in the airway and then start a measurement.
Sampling line
Connector for
sampling line
Airway adapter
Sensor
Connect to patient
Connector to monitor