Mindray BeneView T1, Operator'S Manual

Page: 108 / 286

8-22
8.10 12-Lead ECG Monitoring
8.10.1 Entering the 12-lead ECG Monitoring Screen
1. Refer to the section 8.3.3 ECG Lead Placements to place the electrodes.
2. In the [ ECG Setup ] menu, select [ Others>> ] to enter the [ Others Setup Menu ].
3. Set [ Lead Set ] to [ 12-Lead ], set [ ECG Display ] to [ 12-Lead ].
There are totally 12 ECG waves and 1 rhythm wave displayed on the screen. The rhythm lead is ECG
I
before entering the
12-lead ECG screen.
The [ Filter ] mode is automatically switched to [ Diagnostic ] when the patient monitor accesses the 12-lead full-screen;
the [ Filter ] mode resumes to the configuration before accessing the 12-lead full screen when the patient monitor exit
the 12-lead full screen.
8.10.2 Setting ECG Waveform Sequence
You can select the sequence of ECG waveforms on the 12-lead ECG screen and 12-lead ECG report.
To select the sequence of the ECG waveforms,
1. In the [ ECG Setup ] menu, select [ Others>> ] to enter the [ Others Setup Menu ].
2. Set [
Waveform Layout
] to [
Standard
] or [
Cabrera
].

[ Standard ]: the sequence is I, II, III, aVR, aVL, aVF, V1, V2, V3, V4, V5, V6.

[ Cabrera ]: the sequence is aVL, I, -aVR, II, aVF, III, V1, V2, V3, V4, V5, V6.
8.10.3 Extending the rhythm lead waveform area
You can extend the height of rhythm lead waveform area. To do so,
1. In the [ ECG Setup ] menu, select [ Others>> ] to enter the [ Others Setup Menu ].
2. Set [ECG Display Area ] to [ Extended ].