Fig. 5: Identifying Second-Row Seat Belt, Bolt & Torque Specifications
Courtesy of MAZDA MOTORS CORP.
SECOND-ROW CENTER SEAT BELT REMOVAL/INSTALLATION
1. Turn the ignition switch to the LOCK position.
2. Disconnect the negative battery cable.
3. Remove the following parts:
1. A-pillar trim (See
A-PILLAR TRIM REMOVAL/INSTALLATION
.)
2. Front scuff plate inner (See
FRONT SCUFF PLATE REMOVAL/INSTALLATION
.)
3. Rear scuff plate inner (See
REAR SCUFF PLATE REMOVAL/INSTALLATION
.)
4. Front seat belt lower anchor installation bolt (See
FRONT SEAT BELT
REMOVAL/INSTALLATION
.)
5. B-pillar lower trim (See
B-PILLAR LOWER TRIM REMOVAL/INSTALLATION
.)
6. Front seat belt upper anchor installation bolt (See
FRONT SEAT BELT
REMOVAL/INSTALLATION
.)
7. B-pillar upper trim (See
B-PILLAR UPPER TRIM REMOVAL/INSTALLATION
.)
8. Trunk box (See
TRUNK BOX REMOVAL/INSTALLATION
.)
9. Seat side box (See
SEAT SIDE BOX REMOVAL/INSTALLATION
.)
10. Trunk end trim (See
TRUNK END TRIM REMOVAL/INSTALLATION
.)
11. Third-row seat (See
THIRD-ROW SEAT REMOVAL/INSTALLATION
.)
12. Third-row seat belt lower anchor installation bolt (See
THIRD-ROW SEAT BELT
CAUTION:
z
The ELR (emergency locking retractor) has a spring that will unwind
if the retractor cover is removed. The spring cannot be rewound by
hand. If this occurs, the ELR will not work properly. Therefore, do not
disassemble the retractor.
2008 Mazda CX-9 Grand Touring
2008 RESTRAINTS Seat Belt - Mazda CX-9
Microsoft
Sunday, November 15, 2009 10:19:40 AM
Page 5
© 2005 Mitchell Repair Information Company, LLC.
