Fig. 28: Identifying Joint Shaft Components (AWD) & Torque Specifications
Courtesy of MAZDA MOTORS CORP.
JOINT SHAFT REMOVAL NOTE
1. Separate the right side drive shaft from the joint shaft by using the
SSTs.
2. Remove the nuts.
3. Pull the joint shaft straight out.
4. Replace the deflector and oil seal. (See
TRANSFER OIL SEAL REPLACEMENT
.)
CLIP INSTALLATION NOTE
1. Install a new clip onto the joint shaft with the opening facing upward. Ensure that the diameter of the clip
does not exceed the specification on installation.
2. After installation, measure the outer diameter. If it exceeds the specification, repeat Step 1 using a new
clip.
Outer diameter specification 34.0 mm {1.34 in} max.
CAUTION:
z
The sharp edges of the joint shaft can slice or puncture the oil
seal. Be careful when removing the joint shaft from the
transaxle.
NOTE:
z
If the joint shaft is removed, always replace the deflector and oil seal
of the transfer with new ones.
Fig. 29: Separating Right Side Drive Shaft
Courtesy of MAZDA MOTORS CORP.
2008 Mazda CX-9 Grand Touring
2008 DRIVELINE/AXLES Drive Shaft - Mazda CX-9
Microsoft
Sunday, November 15, 2009 9:50:57 AM
Page 19
© 2005 Mitchell Repair Information Company, LLC.
