1
z
Using the M-MDS, verify the following
PID/DATA monitor.
(See
PID/DATA MONITOR TABLE
.)
{
RES_PT_D
z
Is the resistance of the driver-side pre-tensioner
seat belt normal?
{
Resistance:
1.0-9.7 ohms
Yes
Replace the SAS control module. (See
SAS CONTROL MODULE
REMOVAL/INSTALLATION
.)
No
Go to the next step.
2
INSPECT DRIVER-SIDE PRE-TENSIONER
SEAT BELT CONNECTOR
z
Turn the ignition switch to the LOCK position.
z
Disconnect the negative battery cable and wait
for
1 min or more.
z
Remove the B-pillar lower trim (LH). (See
B-
PILLAR LOWER TRIM
REMOVAL/INSTALLATION
.)
z
Disconnect the driver-side pre-tensioner seat
belt connector. (See
FRONT SEAT BELT
REMOVAL/INSTALLATION
.)
z
Is there any malfunction of the driver-side pre-
tensioner seat belt connector?
WARNING:
z
Handling the air bag system components
improperly can accidentally deploy the air
bag modules and pre-tensioner seat belts,
which may seriously injure you. Read the
service warnings and cautions before
handling the air bag system components.
(See AIR BAG SYSTEM SERVICE
WARNINGS .)
(See AIR BAG SYSTEM SERVICE
CAUTIONS .)
Yes Replace the air bag wiring harness.
No
Go to the next step.
VERIFY WHETHER MALFUNCTION IS IN
DRIVER-SIDE PRE-TENSIONER SEAT BELT
OR RELATED WIRING HARNESS
z
Connect the leads of the SST (Fuel and
thermometer checker) or apply 2-ohm resistance
to driver-side pre-tensioner seat belt connector
Yes Go to the next step.
2008 Mazda CX-9 Grand Touring
2008 RESTRAINTS On-Board Diagnostic (Restraints) - Mazda CX-9
Microsoft
Sunday, November 15, 2009 10:18:46 AM
Page 42
© 2005 Mitchell Repair Information Company, LLC.
