1. Remove the driver-side air bag module.
(See
DRIVER-SIDE AIR BAG MODULE REMOVAL/INSTALLATION
.
2. Connect the
SSTs (Adapter harness)
to the driver-side air bag module as shown in the figure.
Fig. 47: Connecting SST To Driver-Side Air Bag Module
Courtesy of MAZDA MOTORS CORP.
3. Place the driver-side air bag module on the center of the tire wheel with the padded surface facing up. To
secure the air bag module to the tire wheel, wrap a wire (cross section
1.25 mm
2
{0.002 in
2
} or more)
through the wheel and the bolt installation holes of the air bag module
at least 4 times
.
accidentally. To prevent injury while disposing of the air bag
module, make sure to operate (deploy) both driver-side air bag
module inflators simultaneously, following the procedure below.
WARNING:
z
If the air bag module is not properly installed to the tire wheel,
serious injury may occur when the module is operated
(deployed). When installing the air bag module to the tire
wheel, make sure the padded surface is facing up.
Fig. 48: Placing Driver-Side Air Bag Module On Center Of Tire
Wheel
Courtesy of MAZDA MOTORS CORP.
2008 Mazda CX-9 Grand Touring
2008 RESTRAINTS Air Bag System - Mazda CX-9
Microsoft
Sunday, November 15, 2009 10:16:38 AM
Page 35
© 2005 Mitchell Repair Information Company, LLC.
