(vehicle harness-side) and body ground:
{
Combined sensor (CAN2_L): M
{
Combined sensor (CAN2_H): P
z
Is there continuity?
No
Go to the next step.
3
INSPECT THE COMBINED SENSOR
z
Reconnect all disconnected connectors.
Inspect the combined sensor.
(See
COMBINED SENSOR
INSPECTION
.)
z
Is the combined sensor normal?
Yes Go to the next step.
No
Replace the combined sensor, then go to
the next step.
(See
COMBINED SENSOR
REMOVAL/INSTALLATION
.)
4
VERIFY THAT THE SAME DTC IS NOT
PRESENT
z
Clear the DTCs from the memory.
(See
ON-BOARD DIAGNOSTIC
[DSC/RSC]
.)
z
Are the same DTCs present?
Yes
Repeat the inspection from Step 1.
If the malfunction recurs, replace the
DSC/RSC HU/CM, then go to the next
step.
(See
DSC/RSC HU/CM
REMOVAL/INSTALLATION
.)
No
Go to the next step.
5
VERIFY THAT NO OTHER DTCS ARE
PRESENT
z
Are any other DTCs output?
Yes
Go to the applicable DTC inspection.
(See
ON-BOARD DIAGNOSTIC
[DSC/RSC]
.)
No
DTC troubleshooting completed.
2008 Mazda CX-9 Grand Touring
2008 BRAKES On-Board Diagnostic (DSC/RSC) - Mazda CX-9
Microsoft
Sunday, November 15, 2009 9:50:13 AM
Page 42
© 2005 Mitchell Repair Information Company, LLC.
