2
z
Turn the ignition switch to the LOCK position.
z
Disconnect the negative battery cable and wait
for
1 min or more.
z
Disconnect the passenger-side side air bag
module connector. (See
SIDE AIR BAG
MODULE REMOVAL/INSTALLATION
.)
z
Is there any malfunction of the passenger-side
side air bag module connector?
(See AIR BAG SYSTEM SERVICE
CAUTIONS .)
No
Go to the next step.
3
VERIFY WHETHER MALFUNCTION IS IN
PASSENGER-SIDE SIDE AIR BAG MODULE
OR RELATED WIRING HARNESS
z
Connect the leads of the SST (Fuel and
thermometer checker) or apply 2-ohm resistance
to passenger-side side air bag module connector
terminals A and B.
z
Set the resistance of the SST (Fuel and
thermometer checker) to the 2-ohm position.
z
Connect the negative battery cable.
z
Turn the ignition switch to the ON position.
z
Are DTCs B1055, B1996, B1997, B1998 and/or
B1999 indicated?
Yes Go to the next step.
No
Replace the passenger-side side air bag
module.
(See
SIDE AIR BAG SENSOR NO.
1 REMOVAL/INSTALLATION
.)
INSPECT WIRING HARNESS BETWEEN
PASSENGER-SIDE SIDE AIR BAG MODULE
AND SAS CONTROL MODULE
z
Turn the ignition switch to the LOCK position.
z
Disconnect the negative battery cable and wait
for
1 min or more.
z
Remove the column cover. (See
COLUMN
COVER REMOVAL/INSTALLATION
.)
z
Disconnect the clock spring connector. (See
COMBINATION SWITCH
REMOVAL/INSTALLATION
.)
z
Remove the glove compartment. (See
GLOVE
COMPARTMENT
REMOVAL/INSTALLATION
.)
z
Disconnect the passenger-side air bag module
Replace the SAS control module. (See
2008 Mazda CX-9 Grand Touring
2008 RESTRAINTS On-Board Diagnostic (Restraints) - Mazda CX-9
Microsoft
Sunday, November 15, 2009 10:18:46 AM
Page 46
© 2005 Mitchell Repair Information Company, LLC.
