3. Then, select items from the screen menu in the following order.
1. Select "Programmable Module Installation".
2. Select "RCM".
4. Perform the configuration according to the directions on the screen.
5. Retrieve DTCs by the M-MDS, then verify that there is no DTC present.
z
If a DTC (s) is detected, perform the applicable DTC inspection. (See
DTC TABLE
.)
Fig. 20: Identifying DLC-2 Location
Courtesy of MAZDA MOTORS CORP.
SEAT WEIGHT SENSOR CONTROL MODULE REMOVAL/INSTALLATION
1. Turn the ignition switch to the LOCK position.
2. Disconnect the negative battery cable and wait for
1 min or more
.
3. Remove the front passenger seat. (See
FRONT SEAT REMOVAL/INSTALLATION
.)
4. Remove in the order indicated in the table.
Fig. 21: Identifying Seat Weight Sensor Control Module, Connector And Fastener
Courtesy of MAZDA MOTORS CORP.
CAUTION:
z
When the seat weight sensor control module is replaced with a new
one, perform the seat weight sensor calibration using the M-MDS.
(See SEAT WEIGHT SENSOR CALIBRATION.)
2008 Mazda CX-9 Grand Touring
2008 RESTRAINTS Air Bag System - Mazda CX-9
Microsoft
Sunday, November 15, 2009 10:16:38 AM
Page 18
© 2005 Mitchell Repair Information Company, LLC.
