z
If the manual shaft is in a position other than N, shaft it to the N position.
Verify that the selector cable is adjusted properly.
z
If the selector cable is not adjusted properly, adjust it. (See
SELECTOR CABLE
ADJUSTMENT
.)
Inspect the manual shaft lever for deformation.
z
If there is any malfunction, replace the manual shaft lever.
6. Shift the selector lever from P position to D range, then verify that the positions of the selector lever and
the indicator are aligned.
z
If there is any malfunction, inspect the DTC. (See
DTC TABLE [AW6A-EL, AW6AX-EL]
.)
OIL SEAL (MANUAL SHAFT) REPLACEMENT [AW6A-EL, AW6AX-EL]
1. Disconnect the negative battery cable.
2. Remove the air cleaner component. (See
INTAKE-AIR SYSTEM REMOVAL/INSTALLATION
[MZI-3.7]
.)
3. Remove the TCM. (See
TCM REMOVAL/INSTALLATION [AW6A-EL, AW6AX-EL]
.)
4. Remove and discard the oil seal using a tape-wrapped flathead screwdriver.
5. Using the
SST
and a hammer, tap a new oil seal so that the specified oil seal position is obtained.
CAUTION:
z
Water or foreign material entering the connector can cause a poor
connection or corrosion. Be sure not to allow water or foreign
material on the connector when disconnecting.
CAUTION:
z
Do not damage the transaxle case.
z
Do not damage the manual shaft.
CAUTION:
z
Do not damage the oil seal.
Fig. 54: Removing Oil Seal
Courtesy of MAZDA MOTORS CORP.
2008 Mazda CX-9 Grand Touring
2008 TRANSMISSION Automatic Transaxle (AW6A-EL, AW6AX-EL) - Mazda CX-9
Microsoft
Sunday, November 15, 2009 10:29:31 AM
Page 48
© 2005 Mitchell Repair Information Company, LLC.
