z
Turn the ignition switch to the ON position.
z
Measure the fuse block terminal H voltage.
z
Is the voltage
8 V-18 V?
No
Repair the wiring harness between the
battery and fuse block.
4
INSPECT SAS CONTROL MODULE
z
Turn the ignition switch to the LOCK position.
z
Disconnect the negative battery cable and wait
for 1 min or more.
z
Remove the column cover. (See
COLUMN
COVER REMOVAL/INSTALLATION
.)
z
Disconnect the clock spring connector. (See
COMBINATION SWITCH
REMOVAL/INSTALLATION
.)
z
Remove the glove compartment. (See
GLOVE
COMPARTMENT
REMOVAL/INSTALLATION
.)
z
Disconnect the passenger-side air bag module
connector. (See
PASSENGER-SIDE AIR BAG
MODULE REMOVAL/INSTALLATION
.)
z
Disconnect the driver and passenger-side front
seat connectors. (See
FRONT SEAT
REMOVAL/INSTALLATION
.)
z
Disconnect the driver and passenger-side curtain
air bag module connectors. (See
CURTAIN AIR
BAG MODULE
REMOVAL/INSTALLATION
.)
z
Remove the B-pillar lower trim. (See
B-PILLAR
LOWER TRIM
REMOVAL/INSTALLATION
.)
z
Disconnect the driver and passenger-side pre-
tensioner seat belt connectors. (See
FRONT
WARNING:
z
Handling the air bag system components
improperly can control module. accidentally
deploy the air bag modules and pre-tensioner
seat belts, which may seriously injure you.
Read the service warnings before handling the
air bag system components.
(See AIR BAG SYSTEM SERVICE WARNINGS .)
(See AIR BAG SYSTEM SERVICE CAUTIONS .)
Yes
Replace the SAS control module. (See
SAS CONTROL MODULE
REMOVAL/INSTALLATION
.)
No
Repair the wiring harness between the
2008 Mazda CX-9 Grand Touring
2008 RESTRAINTS On-Board Diagnostic (Restraints) - Mazda CX-9
Microsoft
Sunday, November 15, 2009 10:18:47 AM
Page 71
© 2005 Mitchell Repair Information Company, LLC.
