DTC B104D, B2226, B2227, B2855
z
Remove the B-pillar lower trim. (See
B-
PILLAR LOWER TRIM
REMOVAL/INSTALLATION
.)
z
Disconnect the driver and passenger-side pre-
tensioner seat belt connectors. (See
FRONT
SEAT BELT
REMOVAL/INSTALLATION
.)
z
Disconnect the SAS control module connectors.
(See
SAS CONTROL MODULE
REMOVAL/INSTALLATION
.)
z
Disconnect the passenger-side side air bag
sensor No.1 connector.
z
Inspect the wiring harnesses between SAS
control module terminal 2K and passenger-side
side air bag sensor No.1 terminal A, SAS
control module terminal 2G and passenger-side
side air bag sensor No.1 terminal B for the
following:
{
Short to ground
{
Short to power supply
{
Open circuit
z
Is the wiring harness normal?
No
Replace the air bag wiring harness.
3
INSPECT SAS CONTROL MODULE
z
Connect the SAS control module connector.
z
Connect the driver and passenger-side pre-
tensioner seat belt connectors.
z
Connect the passenger-side side air bag sensor
No.1 connector.
z
Connect the driver and passenger-side curtain
air bag module connectors.
z
Connect the driver and passenger-side front seat
connectors.
z
Connect the passenger-side air bag module
connector.
z
Connect the clock spring connector.
z
Connect the negative battery cable.
z
Turn the ignition switch to the ON position.
z
Are DTCs B104C, B104F, B1050 and/or U2018
indicated?
Yes
Replace the SAS control module. (See
SAS CONTROL MODULE
REMOVAL/INSTALLATION
.)
No
DTC troubleshooting completed.
2008 Mazda CX-9 Grand Touring
2008 RESTRAINTS On-Board Diagnostic (Restraints) - Mazda CX-9
Microsoft
Sunday, November 15, 2009 10:18:46 AM
Page 37
© 2005 Mitchell Repair Information Company, LLC.
