Fig. 95: Identifying Blinking Pattern - Keyless Warning Light
Courtesy of MAZDA MOTORS CORP.
24. After verifying that the keyless warning light goes out, turn the ignition switch to the LOCK position
using key 1, and then remove the key.
25. Repeat Steps 22 to 24 using key 2 instead of key 1.
26. Start the engine using the card key.
27. Verify that the security light and keyless warning light operate as follows:
z
From the point that ignition switch is turned to the ON position, the security light illuminates
for
approx. 3 s
, and goes out.
z
The keyless warning light illuminate when the ignition switch is turned to the ON position for
approx. 1 min
, and goes out.
28. After verifying that the keyless warning light goes out, turn the ignition switch to the LOCK position.
29. Verify that the all keys can start the engine for
5 s or more
after the procedure.
NO.8 THE PROCEDURE FOR WHEN SEVERAL PARTS (PCM, KEYLESS CONTROL MODULE,
NOTE:
z
If three or more keys have already been programmed, perform Steps
22 to 24.
CAUTION:
z
Remove any key from the key cylinder.
z
Close all doors.
z
Bring the card key into the vehicle.
2008 Mazda CX-9 Grand Touring
2008 BODY & ACCESSORIES Security and Locks - Mazda CX-9
Microsoft
Sunday, November 15, 2009 10:47:59 AM
Page 76
© 2005 Mitchell Repair Information Company, LLC.