Mount the OIT to the Panel
4
STEPS:
1. Prepare the four screw clamps for the BLU300 by inserting the clamps into the slots of the back
enclosure as show in the illustration above.
2. Snap the OIT into the panel cutout using the plastic brackets of the back enclosure. Make sure that all
metal clamps are properly in position.
3. Tighten the screw clamps until all are uniformly snug.
CAUTION: Do not over-tighten the screws beyond snugness, or you may damage the housing.
REINSTALLATION: Because the gasket will take a “set” to the panel, be sure to reinstall the OIT to the same panel cutout
when a NEMA 4 seal is required. For best results, also replace the gasket itself.
Configuration Wiring
The OIT must be configured for a particular protocol before use. The
BlueLeaf
software (used on a PC with Windows 95 or
higher) is used for configuring the OIT. For detailed instructions on installing and using the software, please refer to the
software documentation section of this manual.
Connect the OIT to the PC for Configuration
To configure the OIT using Maple System’s configuration software, you will need the OIT Configuration Cable, Maple P/N
7431-0102. Connect the end marked “HMI” into the RS-232 port on the OIT and connect the end marked PC into the proper
1010-0300, Rev 02
14
Blue Series Installation & Operation Manual
Installing the Screws on the OIT